The Milescraft AngleFinder is a reference for angle measurements for precise woodworking. Looking to divide your angle in half for a miter saw set-up? Look no further, the AngleFinder™ does all the work for you. The yellow angle divider divides any angle in half. The AngleFinder™ features an angle measurement readout, allowing you to set your angle once determined. The ratcheting locking lever allows you to secure your angle in place while transferring it to your miter saw. Looking to find an angle in a tight spot? The retractable edge guides allow you to get into confined spaces and determine the angle.
AngleFinder Features
- Retractable edge guides for layout
- Finds angles between two points on inside or outside corners
- Angle divider for easy miter saw setup
- Notches for holding bar clamps upright when framing
WARNING: Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov/product
(verified owner)
This is probably the best “angle-finder” I have come across simply because of the center saw-blade alignment tab – that’s the bomb!
(verified owner)
Great service
I Just purchased this today from Woodcraft in Richardson, TX. Excellent tool! As anyone who has done trim work knows, 90 degree inside or outside corners are never exact, let alone any other odd angled walls. that is why trim work is so difficult, measuring and cutting those angles must be exact to get the fit perfect. This is simplicity at it’s finest. Do not confuse this statement with cheap or poorly made. It is simple in it’s design but excellent in it’s quality. That is what will make this a go-to tool for years to come. I’m 72 years old and wish this tool was available or at least I had known about it years ago when I did much more carpentry and trim work. There are other tools out there that do the same task but they will be more expensive. As much as 8 or 9 times as much. I would recommend this tool to anyone wanting to execute clean-even-cut angled trim miters.
(verified owner)
Great tool Milescraft ?
(verified owner)
another good tool!!
The perfect angle finder, and angle copying device!!!
The new ratcheting lock system that holds the tool in place after getting the angle, is perfect! It gives more than enough pressure now to keep the desired angle needed.
Thanks for redesigning the locking mechanism! It’s become invaluable to me and my daily workload!
Can’t wait to see what other great ideas Milescraft provides in the future!