BladeChanger keeps saw blades from moving when changing blades, helping to avoid blade damage and keeping fingers away from sharp teeth. Featuring a universal step design, the BladeChanger fits any 10″, 8″ Dado and 7-1/4″ saw blade. With an open design that allows you to view your blade while changing and a large handle for a firm grip, the BladeChanger makes a great addition to any shop.
BladeChanger Features
- Universal step design fits all 10″ (250 mm), 8″ dado (200 mm), and 7-1/4″ (184 mm) saw blades
- Open design allows you to view your blade while changing
- Large handle provides a firm grip and keeps knuckles away from the wrench
- Hang holes/high visibility yellow – easily stored and located in a busy shop
WARNING: Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov/product
The blade changer from milescraft is a great well made product. The plastic is well constructed material and is built tough. If you were to drop it it wouldn’t break! It’s allowed to use a variety of saw blades depending on your need. Although I didn’t get to use it like your supposed to because of my dewalt tablesaw has riffing knifes that were in the way I was still able to hold the blade in place to remove the blade when it was time to change them.
(verified owner)
Works great, very good quality!
(verified owner)
It’s a little to deep where it overlaps the saw blade on a 10″ saw, so that you can’t use a straight wrench and must use an offset wrench . On certain blade tooth patterns (Freud Diablo Rip), it does not hold well when tightening . It works well for loosening , which is more important, since you don,t need to tighten blades more then snug .